I am about to have a block machined for my Pinto.
it will be tunnel bored and decked.
My question is what piston to cylinder clearances are recommended.
It is to be .060 " OS and running ACL cast pistons.
It will be used in my gravel rally car.
thanks in advance for any advice
piston to cylinder clearances
Moderator: Moderators
1 post
• Page 1 of 1
piston to cylinder clearances
by INBreplica » Sat Nov 06, 2010 2:50 pm
-
INBreplica - P Plater - C3 License
- Posts: 93
- Joined: Fri Jun 11, 2010 11:14 am
1 post
• Page 1 of 1
Return to Pinto 1.6 / 1.8 / 2.0 / 2.?
Who is online
Users browsing this forum: No registered users and 4 guests