Page 1 of 1
Pinto head and pair of Weber 48 DCOE
Posted:
Mon Jun 06, 2011 3:11 pmby Baden
I'm on the search for an injection casting Pinto head and a matched pair of 48 DCOEs (not DCO/SP). The RS is getting some grunt.
Baden
0411 667 637
Thanks :)
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Thu Jul 14, 2011 3:49 amby Miniliteman
Regards, Leon.
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Sat Jul 16, 2011 10:23 pmby Darren W.
Try this from topic NEW WEBBERS in Fuel Systems - carbies, EFI etc.
As with the current exchange rate from AUS to USA new might be cheaper
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Sun Jul 17, 2011 2:42 amby Miniliteman
Darren, these US carbs are DCO/SP 's not DCOE.
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Sun Jul 17, 2011 8:11 amby Darren W.
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Sun Jul 17, 2011 8:17 amby MK1_Oz
Danny M was very specific with me that I should get 48DCOE over DCO/SP. He had a reason that I cannot recall...something more than just chokes.
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Sun Jul 17, 2011 8:28 pmby Miniliteman
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Mon Jul 18, 2011 7:22 pmby Darren W.
Good info Leon, and the same old story of they don't build them like they used to. All the new OE ball joints that I have seen lately are what I would call half worn (too easily moved by hand) so you only get two to three years use if your lucky.
Re: Pinto head and pair of Weber 48 DCOE
Posted:
Fri Aug 05, 2011 1:59 pmby Baden
Thanks to Leon I have a set of 48s (Thanks Leon!)
Just need the head now....