RS Motorsport :: Classic Speed Restored

Hi guys.
I am fitting adjustable front control arms to my Escort, these arms have a rose joint where they bolt up inside the cross member.
I need 4/13mm cone shaped spacers made up. anyone with a metal lathe willing to help?

And should i run a larger diameter bolt through the cross member to suit the rose joint?.
Mark

Hi Mark,
Have a Lathe and can help you.
Live near Ipswich.
Les.
les.mellor@bigpond.com

You could make the spacers to suit the original bolt, step the ends so they locate in the rose joint. If you're using these on a road car it might pay to hide the rose joint/adjuster. I've used a piece of pipe insulation (like roll cage padding) that fitted tightly over the adjuster/rose joint. I was intending on using the car for rallies so my main reason to cover it up was to keep crap out of it.

PM sent Les, i hope it made sense.

Hi Mark,
Have been trying your mobile for a couple of of days with no result.
Need to talk to you before starting.
32946888
Thanks,
Les.