Camber Pins
Posted: Mon Aug 24, 2009 9:47 amDavid W,
Where u heading with this modification ??
RS Motorsport :: Classic Speed Restored
Carrying on from \"The Works Escorts\" forums of years past, RS Motorsport is dedicated to those small Fords from the Golden Era of Motorsport, namely the 60's, 70's and 80's.
http://rsmotorsport.com.au/forums/
Camber Pins
Page 1 of 1
Posted: Mon Aug 24, 2009 9:47 amPosted: Mon Aug 24, 2009 12:08 pmPosted: Mon Aug 24, 2009 5:00 pmPosted: Mon Aug 24, 2009 6:12 pmPosted: Mon Aug 24, 2009 6:24 pmPosted: Mon Aug 24, 2009 6:52 pmPosted: Mon Aug 24, 2009 8:40 pmIts a daily driver. Car has been pulled apart, repainted, rebuild the motor etc etc. As its comes back together I'm upgrading or replacing the bits that need attention (ie: new urethane, brake pads, rebuild mater cylinder, stainless lines etc etc). The car has had camber pins installed at some part of its life and when I pulling the front end apart I noticed the camber pins had a bit of a curve and the thread wasn't 100%. Simple solution (so I thought) - replace them.
I can always fall back to a Std Cross member sitting in the garage
I can always fall back to a Std Cross member sitting in the garage
Posted: Mon Aug 24, 2009 9:13 pmPosted: Mon Jan 11, 2010 5:55 pm