Page 1 of 1
Type 9 Input Shaft, straight cut gearset
Posted:
Sat Feb 23, 2013 11:28 amby SportsSedanSteve
Due to being done over by a certain eBay seller I have a T9 input shaft spare after building the new rocket box. I should qualify this and state that I think it's a T9-17tooth, standard length input shaft.
PM if interested.
Re: Type 9 Input Shaft, straight cut gearset
Posted:
Sat Feb 23, 2013 8:49 pmby Danny M
Whats the part no. on it?
Re: Type 9 Input Shaft, straight cut gearset
Posted:
Tue Feb 26, 2013 10:43 amby SportsSedanSteve
I'll call you when I get home on break. I haven't really looked at it since Andy pressed the bearing off but there were no numbers visible to me. i'm going off the turbosport T9 thread that shows the synchro rings being the same size between 1st/2nd and 3rd/4th.
Only part number on the whole kit was the layshaft. Just had a look at the invoice for the proper shaft and Quaife have sent me a "short" input shaft so possibly this T9 is a short too(they are the same length)
Re: Type 9 Input Shaft, straight cut gearset
Posted:
Wed Feb 27, 2013 4:05 amby Danny M
Steve they have the part numbers etched in to the back face of the gears as I have a few left overs from the T9's
Re: Type 9 Input Shaft, straight cut gearset
Posted:
Fri Mar 01, 2013 2:42 pmby SportsSedanSteve
Ok, part number is E13Z113 and I reckon the DOM is 12/99. So, does that make it T9?
Re: Type 9 Input Shaft, straight cut gearset
Posted:
Fri Mar 01, 2013 2:47 pmby SportsSedanSteve
Its a match off my QKE15Z gearset drawing from Quaife, the 2 is a Z on the drawing!