Page 1 of 1
Pinto Parts
Posted:
Sun Oct 16, 2011 8:58 pmby johnw
Got a few Pinto parts that are now surplus if anyone is interested:
Gonzo Headers
Big Valve Cylinder head, Tighe Cross Drilled camshaft, Isky springs, alloy retainers.
Kent alloy Vernier
Kent alloy Jackshaft Pulley
2 x 45mm Weber manifold (never used)
Re: Pinto Parts
Posted:
Sun Oct 16, 2011 9:01 pmby RallyPack
prices?
Re: Pinto Parts
Posted:
Sun Oct 16, 2011 9:17 pmby ozstang65
Hi John, did I ever give you the address to send the other manifold to?? Been too long....
Re: Pinto Parts
Posted:
Sun Oct 16, 2011 9:31 pmby johnw
Hi Scott, funny you mention that, just pulled manifold off car this arvo, finally getting around to pulling engine out, and have been searching for the bit of paper I wrote your address on. Was going to give you a call in the morning. if you see this before then can you advise delivery address if not I'll call.
Re: Pinto Parts
Posted:
Sun Oct 16, 2011 10:48 pmby MK1_Oz
any details on gonzo's?
Re: Pinto Parts
Posted:
Mon Oct 17, 2011 6:22 amby johnw
What sort of info are you after, Danny Mischok had them made, to his spec, about 18 months ago, they are jet coated and in good condition, they have a slight dent on the bottom courtesy of bouncing over a high curb at Morgan Park. I am only getting rid of them because am going to YB.
Re: Pinto Parts
Posted:
Mon Oct 17, 2011 12:00 pmby Danny M
John
How much for the pipes
Re: Pinto Parts
Posted:
Mon Oct 17, 2011 7:57 pmby MK1_Oz
Yeah how much for the pipes? (dont think my pockets are as deep as Danny's :( )
Re: Pinto Parts
Posted:
Mon Oct 17, 2011 8:42 pmby johnw
All parts have been sold as one lot, thanks everyone for your interest
Re: Pinto Parts
Posted:
Mon Oct 17, 2011 8:52 pmby MK1_Oz
poss would have been out of my league anyway
Re: Pinto Parts
Posted:
Thu Oct 20, 2011 9:20 pmby Belly
Hey John you owe me a beer
Hey good you sold it all and will be good to see the YB going
Belly