Page 1 of 1
Type 9 Pull Down
Posted:
Thu Dec 22, 2016 10:13 pm
by MK1_Oz
As mentioned in another thread I have a T9 with Quaife H/D S/C synchro internals. I have pulled all the box apart but cannot get the mainshaft separated from the intermediate case. I have removed the very large circlip that holds the bearing into the intermediate case and also the small circlip around the mainshaft. Is that all I remove then press off the shaft? I don't have a home press but made something that wouldn't budge it. Will take it to my works workshop tomorrow to see if they can help but just want to ensure I am doing it right before I break something!!!!!
Re: Type 9 Pull Down
Posted:
Fri Dec 23, 2016 8:55 am
by MK1_Oz
Success.....found another mechanic at work to help. Came out like butter!
Re: Type 9 Pull Down
Posted:
Fri Dec 23, 2016 9:39 pm
by Danny M
LOL should you be really touching it Glenn?
Re: Type 9 Pull Down
Posted:
Sat Dec 24, 2016 7:29 am
by MK1_Oz
Of course.....how else will I learn??
Re: Type 9 Pull Down
Posted:
Thu Aug 10, 2017 5:25 pm
by MK1_Oz
EDIT: Not to worry......
Re: Type 9 Pull Down
Posted:
Fri Aug 11, 2017 6:04 am
by jpayne
find where that spare ring went?
JP
Re: Type 9 Pull Down
Posted:
Fri Aug 11, 2017 10:19 am
by MK1_Oz
Just after I typed my previous entry I finally found a Quaife diagram of the HD gearkit (turned out to be under my nose). I am pretty sure I know where it goes and will pull the box down in a minute (separates cage roller bearings under #1 gear.)........I hope........