RS Motorsport :: Classic Speed Restored

Posted: **Tue Feb 07, 2012 6:40 pm**

Guys,

Help needed! Can someone tell me what this connection is on the clutch release bearing pipe outlet?

It looked like a push-fit connection? Where can I get the female end that fits on it?

Never seen one before?

Posted: **Tue Feb 07, 2012 7:15 pm**

How about doing away with it and putting an AN to flare fitting directly into the housing? Then use a flex hose from there to a fitting on the body somewhere.

Posted: **Tue Feb 07, 2012 7:20 pm**

Posted: **Tue Feb 07, 2012 7:59 pm**

Sorry boss... :axe:

Posted: **Sat Feb 11, 2012 10:45 am**

As ozstang has said just replace, its a stupid mondeo connection. Also make sure that the bearing mount pipes are mounted vertically in the box as they wont bleed properly if mounted any other way. I fitted a hydraulic quick connect high on the firewall on mine so i could bleed while out of car then connect when installed.

Mik

RS Motorsport :: Classic Speed Restored

Hydraulic clutch pipe connection

Hydraulic clutch pipe connection

Re: Hydraulic clutch pipe connection

Re: Hydraulic clutch pipe connection

Re: Hydraulic clutch pipe connection

Re: Hydraulic clutch pipe connection