RS Motorsport :: Classic Speed Restored

Hi all....no doubt this has been asked before but can't seem to find it...will the standard 1600 xflow 4 spd manual box, fly, clutch, drive shaft, etc. marry up to a 2lt with existing auto? (replacing). Im presuming i'll need a clutch cable as well.
All info appreciated......l

Also ...probably a long shot but anyone know where i can get mag wheel nuts (dragway 4 spokers) to fit the esky?
Thanks

jim

Im doing a similar conversion (from 1600 to 2ltr mk1 cortina 2000e gearbox though).
You will need 2ltr Flywheel,clutch assembly then gear box will bolt up and the the starter motor shouldnt be a drama bolting up either.

Make sure you get the clutch fork and spacer,thrust bearing obviously.

And use the auto cross member.there is a lot more room under there with an auto tunnel

Don't forget to use a spigot bearing !