G'day folks,
Urgent help needed!
Thought I had the wipers sorted, tested all good on the bench and got the things to self park but neglected to realise the body also earths through the chassis all the time, which didn't work with however I had the wires connected. Anyway, not important... I'm back to square one.
I had a look at the threads on this forum but my wiring differs (although somewhat similar) from those pictured/described and the wiring was all chopped up with no original harness/switchgear when I got it so no reference there.
I would experiment a bit more, but last time I did that I short circuited a wire and had to solder it back on. As it's the only wiper motor I have and I'm leaving for Targa in a few days, I don't won't to find out the hard way again.
Wires out of motor are as follows:
Green
Black (both green and black meet at a moulded two pin plug)
Brown
Light green with brown stripe
Darker green with blue stripe
I have a constant power feed wire going to the motor, and two ground wires that lead to a DPST switch which grounds the motor one of two possible ways (was just going to connect up the high speed). I think I'm on the right track with the switching arrangement. I almost understand what should work but I really want some confirmation as the wires differ from what others have described and what I thought should work on the bench didn't work as expected, and I'm not usually too bad with wires and stuff, so help me!
What do I connect where?????????