RS Motorsport :: Classic Speed Restored

Hi all, I briefly touched on this in my build thread a while ago but i'll put it out here as well. This pedal box came with the car, some have already hinted that it may be Rally Design. Having said that does anyone have any comments on its suitability for a circuit car. If it isn't up to the job, can it be modified to suit or is it better off getting rid of it. It has Wilwood 0.625 & 0.75 cylinders.

Thats a MK1 unit init ?

http://www.rsmotorsport.com.au/forums/v ... =3989#3989

from

www.compbrake.co.uk.


I have one.

http://www.rsmotorsport.com.au/forums/v ... php?t=1142

bit o modifying here and there........

.............and as you can see I had a MK2 gartrec one.


Which I struggled to see the additional quality in.

There has been much comment made about the rally design pedal box. From memory comment about the flex in the pedals under hevey load. Many prefer a plated/reinforced (plates welded across the back) standard pedal in their boxes. Im not sure there is much in the box design itself. The master cylinders are approximately right depending on application, but again willwood sometimes has been described as the lower end stuff.
Whose bias bar do they use. Someone did a calculation a few years ago and suggested some bias bars may not structurally be sufficient to withstand the forces applied, thoigh as the pedal bends so much it might not be much an issue with that box.

Cheers,

JP

These are the ones I got from you last time Danny, no issues at all with them if I recall. What brand are they?

this one was cheap....

Hi Danny - you have PM.